Parallel Port Controller Using
Matlab – External device controller using Matlab:
This project has two sections. An opening GUI in
SIMPLE DEVICE CONTROL MODE and a STEPPER CONTROLLER .In SIMPLE DEVICE CONTROL
MODE you can control individual devices (here leds) through pins 2 to 9
parallel port. As you check any check box the corresponding LED blinks. As you
uncheck it, LED stops blinking. When you push the push button ‘STEPPER
CONTROLLER‘, the GUI for STEPPER CONTROLLER pops up. There are 3 data to be
selected namely Stepping mode, delay (in ms), and the direction (Forward or
reverse). Stepping modes are 3 types namely single step, half step and high
torque stepping modes. Select the stepping mode, direction, delay and click on
the START button .You will get the appropriate output.
No comments:
Post a Comment